Makita UB402MP Manual De Instrucciones página 7

Installing the end nozzle
Align the protrusion on the blower pipe with the groove
on the end nozzle, then attach the end nozzle to the
blower pipe, and then turn the end nozzle to lock it into
place.
Fig.9
► 1. Triangle mark 2. End nozzle 3. Blower pipe
To remove the end nozzle, perform the installation
procedure in reverse.
NOTE: The length of the nozzle can be changed by
moving the nozzle as shown in the figure.
Fig.10
1
2 3
Installing the flat nozzle or
extension nozzle
Optional accessory
1. Remove the end nozzle from the attachment.
2. Attach the flat nozzle or extension nozzle to the
attachment, and then turn it to lock it into place.
1
2
Fig.11
► 1. Flat nozzle 2. Extension nozzle 3. Attachment
Installing the gutter nozzle set
Optional accessory
1. Remove the end nozzle, extension nozzle, or flat
nozzle from the attachment.
2.
Loosen the screw on the small hose clamp, and
pass the hose clamp through the attachment.
2
Fig.12
► 1. Screw 2. Hose clamp (small) 3. Attachment
7 ENGLISH
1
3
3