Broan ALLURE QS3 Serie Manual Del Usuario página 3

ALLURE + QS3 SERmES
RANGE HOOD
Page 3
PREPARE THE HOOD PREPARE THE HOOD
7 Remove
Teflon_coated
bottom cover
from hood+ Set
cover and
mounting
screws aside+
Teflon® is a
trademark of DuPonL
r_ Remove
Damper/Duct
Connector
from inside
the hood. Set
connector
aside - with
mounting
screws and
parts bag.
DAMPER/
DUCT
CONNECTOR
[_ Remove
either top or
back wiring
knockout and
install
approved
Electricam
Cable Clamp+
TEFLON®-COATED BOTTOM COVER
(Held in p/ace tdth 2 screws)
ELECTRICAL CABLE CLAMP
AIR CHUTE
Remove Air
Chute - held in
place with one
(1) screw.
NOTE: Be
careful not to
disconnect any
wires+
+7 Remove Baffle
from air chute.
\
BAFFLE
BAFFLE
\
Nen-Ducted Installation - Skip to Step 15.
The following
Stops (6 thru
14) are for
DUCTED
INSTAL LA 770N
ONLX
(3) #8 SCREWS LIGHT
PANEL
+7 Remove _ Panel - held in place with (3) #8 screws and
(2) #8 screws. Disconnect light assembly wire harness
(white connector).
rq
Rotate baffle.
Reinsert baffle into
air chute (as
shown) so that
baffle tabs fit all the
way into sBots in air
chute. An audible
"click" will be heard
when fully installed.
This will close off
the air flow through
the non-ducted
slots on top of
hood.
SLOTS
H_ Re-install air chute, re-connect wire
harness, and replace light panel+
NOTE: Be careful not to trap wires
between _ort fin and light panel+
TABS
SUPPORT FIN