Publicidad
Idiomas disponibles
Idiomas disponibles
6. Service
a. Have your power tool serviced by a
qualified repair person using only identi-
cal replacement parts. This will ensure
that the safety of the power tool is main-
tained.
1. Safety warnings common for
grinding, sanding, wire brushing,
polishing or carving operations:
a. This power tool is intended to function as
a grinder, sander, wire brush, polisher, or
carving tool. Read all safety warnings, in-
structions, illustrations and specifications
provided with this power tool. Failure to
follow all instructions listed below may
result in electric shock, fire and/or serious
injury.
b. Operations such as cutting-off are not
recommended to be performed with this
power tool. Operations for which the
power tool was not designed may create a
hazard and cause personal injury.
c. Do not use accessories which are not
specifically designed and specified by the
tool manufacturer. Just because the acces-
sory can be attached to your power tool, it
does not assure safe operation.
d. The rated speed of the accessories must
be at least equal to the maximum speed
marked on the power tool. Accessories
running faster than their rated speed can
break and fly apart.
e. The outside diameter and the thickness of
your accessory must be within the capac-
ity rating of your power tool. Incorrectly
sized accessories cannot be adequately
guarded or controlled.
f. The arbour size of wheels, sanding drums
or any other accessory must properly fit
the spindle or collet of the power tool.
Accessories that do not match the mount-
ing hardware of the power tool will run
out of balance, vibrate excessively and may
cause loss of control.
GWG12V-20S Die Grinder OSI Final for Approval 20230627.indd 5
GWG12V-20S Die Grinder OSI Final for Approval 20230627.indd 5
General Power Tool Safety Warnings
Power Tool-Specific Safety Warnings
SAVE THESE INSTRUCTIONS
b. Never service damaged battery packs.
Service of battery packs should only be per-
formed by the manufacturer or authorized
service providers.
g. Mandrel mounted wheels, sanding drums,
cutters or other accessories must be
fully inserted into the collet or chuck. If
the mandrel is insufficiently held and/or
the overhang of the wheel is too long, the
mounted wheel may become loose and be
ejected at high velocity.
h. Do not use a damaged accessory. Before
each use inspect the accessory such as
abrasive wheels for chips and cracks,
backing pad for cracks, tear or excess
wear, wire brush for loose or cracked
wires. If power tool or accessory is
dropped, inspect for damage or install
an undamaged accessory. After inspect-
ing and installing an accessory, position
yourself and bystanders away from the
plane of the rotating accessory and run
the power tool at maximum no-load speed
for one minute. Damaged accessories will
normally break apart during this test time.
i. Wear personal protective equipment.
Depending on application, use face shield,
safety goggles or safety glasses. As ap-
propriate, wear dust mask, hearing protec-
tors, gloves and workshop apron capable
of stopping small abrasive or workpiece
fragments. The eye protection must be
capable of stopping flying debris generated
by various applications. The dust mask or
respirator must be capable of filtrating par-
ticles generated by the particular applica-
tion. Prolonged exposure to high intensity
noise may cause hearing loss.
j. Keep bystanders a safe distance away
from work area. Anyone entering the
work area must wear personal protective
equipment. Fragments of workpiece or of
a broken accessory may fly away and cause
injury beyond immediate area of operation.
-5-
6/27/2023 10:52:40 AM
6/27/2023 10:52:40 AM
Publicidad
