Publicidad
Idiomas disponibles
Idiomas disponibles
PACKING AWAY THE SCREEN
STEP 1:
Unhook the retaining bracket at the top of the screen from the stand hook
and slowly guide the screen back into the housing until the screen is fully
retracted.
STEP 2:
Now loosen the tensioning nut on the stand rod and push the rod back to-
gether to its original length. Tighten the tensioning nut carefully again.
STEP 3:
Loosen the tensioning lever on the carrying handle and return the housing to
its original position, then secure the tension lever.
STEP 4:
Rotate the enclosure 90 degrees back to the vertical position. It may be
necessary to Release the tension lever again allowing the enclosure to move
upwards so that it does not hit the ground when turning. Afterwards tighten
the lever again.
STEP 5:
Fold the tripod feet together.
At the upper end of the housing end cap you will find a
round recess into which the tripod hook is inserted for
transport. To do this, loosen the rod and insert the hook
into the recess. Afterwards, the tensioning nut should be
tightened again and the screen can be transported via
the carrying handle.
If you use a tripod bag from celexon (sold separately)
the rod does not have to be inserted into the inlet for the
screen to fit into the bag.
celexon Europe GmbH | Gutenbergstraße 2 | 48282 Emsdetten | DE
6
Publicidad
