Descargar Imprimir esta página

Husqvarna Z560XS Manual Del Usuario página 27

Publicidad

Idiomas disponibles

Idiomas disponibles

Problem
The battery does not charge.
The product moves slowly, with
irregular speed or not at all.
The drive of the blades do not
engage.
The transaxle leaks oil.
The cutting result is unsatisfac-
tory.
Transportation
The product is heavy and can cause crush
injuries. Be careful when you load it onto or off
a vehicle or trailer.
Load the product in reverse on approved ramps
of a maximum operation angle of 10°. Do not lift
the product.
Use an approved trailer for transportation of the
product.
Make sure that you have knowledge of local
road traffic regulations before transportation of
the product in a trailer or on roads.
Stop the fuel supply of the product.
Lock the product with approved devices, such as
straps. Use tie-down points on the product. The
parking brake is not sufficient to lock the product
during transportation.
2312 - 001 - 29.11.2023
Cause
The connection at the cable connectors on the battery terminals is bad.
To clean the battery on page 18 .
Refer to
The charging lead is disconnected.
The charging system does not operate correctly.
The parking brake is engaged.
The hydraulic release lever is engaged.
The drive belt on the transmission is loose or damaged.
There is air in the hydraulic system.
The drive belt on the mower deck is loose.
The electromagnetic coupling contact is loose.
A fuse is blown. Refer to
The seals, housing or gaskets are damaged.
There is air in the hydraulic system.
The tire pressure is different on the right and left sides. Refer to
pressure on page 20 .
The blades are damaged.
The suspension of the cutting deck is not level.
The blades are blunt. Refer to
The product is operated at too high forward or rearward speed. Refer to
get a good cutting result on page 15 .
The grass is long or wet. Refer to
There is grass blockage in the cutting deck. Refer to
on page 18 .
Transportation, storage and disposal
Fuses on page 5 .
To examine the blades on page 22 .
To get a good cutting result on page 15 .
To tow the product
WARNING:
product, you must read and understand
the safety chapter. Refer to
page 6 .
Be careful when you tow the product.
Operate the product slowly when you tow the
product.
The breaking distance increases when you tow
the product. Make sure to decreases the speed
in time.
For safe operation, do wide turns.
Do not tow near ditches, open water, and other
dangerous areas.
Tire
To
To clean the product
Before you tow the
Safety on
27

Publicidad

loading