PEDROLLO STEADYPRES Manual página 23

WARNINGS
• Please read all parts of this manual carefully before installing and using the product.
• Check that the rating plate data is as required and matches the facilities.
• Only qualified personnel capable of making electrical connections in accordance with national regulations may carry out
installation and maintenance.
• STEADYPRES must only be used for the purpose and operation for which it was designed. Any other application and use
should be considered misuse and hazardous.
• In the event of a fire at or near the installation site, do not use water jets, but use suitable extinguishers (powder, foam,
carbon dioxide).
• Install the equipment away from heat sources in a dry, covered place in accordance with the specified degree of protection
(IP).
• Only qualified technicians who are aware of the safety regulations in force may carry out any installation and/or mainte-
nance work.
• Use of non-original spare parts, tampering or improper use will void the product warranty.
• The manufacturer cannot be held liable for damage deriving from misuse of the product and is not responsible for damage
caused by maintenance or repairs carried out by unqualified people and/or using non-original spare parts.
2
DURING THE FIRST INSTALLATION PHASE AND IN THE EVENT OF MAINTENANCE, ensure that:
• THERE IS NO LIVE VOLTAGE on the electricity mains.
• The system IS NOT PRESSURISED
• The electrical power mains is equipped with safety devices and, in particular, a high sensitivity differential switch (30
mA in class F and B) suitable to protect against fault currents, alternating type, unipolar button, continuous with high
frequency. Also check that the earthing complies with the regulations.
• Before removing the cover of the inverter or starting interventions on it, disconnect the system from the electrical mains
at least 5 minutes so that the capacitors have the time to discharge using the built-in discharge capacitors;
• Having carried out the electrical connection on the system, check the settings of the inverter.
• Do not remove the cover and/or disconnect power if the inverter is running.
2
CAUTION: in out of service status, the STEADYPRES remains live; before any intervention you must discon-
nect the voltage from the unit.
1
EMERGENCY STOP
While STEADYPRES is running, you can make an emergency stop by disconnecting the power supply to the unit. If interven-
tion is being carried out, ensure there is no VOLTAGE on the electricity mains. Make sure that the system is NOT PRESSURISED.
ENGLISH |
21