Connections - Interchange NSR83-21HD Manual Del Operador

NSR83-21HD
12
OPERATING THE NAILER

CONNECTIONS

Fittings
1
• Install a female coupler to the hose. The female
1
coupler will connect to the quick release that fits
the tool.
Filter-Regulator-Lubricator
• Never connect nailer to pressure that potentially
exceeds 120psi.
• Filter-regulator-lubricator units supply an optimum
condition for the nailer and extend the nailer life.
These units should always be used.
Filter
• The filter removes moisture and dirt mixed in
compressed air.
• Keep the filter clean by maintaining tool regularly.
2
• Drain daily.
2
Regulator
• The regulator controls the operating pressure for
safe operation of the nailer.
• Inspect the regulator before operation to be sure it
operates properly.
Lubricator
• The lubricator supplies an oil mist to the nailer.
• Inspect the lubricator before operation to be sure
the supply of lubricant is adequate.
3
• If an inline lubricator is not used, a few drops of oil
will need to be added to the air inlet before each
3
use.
Air Hose
• Air hose must have a minimum working pressure
rating of 120psi or 150% of the maximum pressure
produced in the system, whichever is higher.
Interchange Brands Framing Nailers: Operator's Manual