Testing The Nailer - Interchange NSR83-21HD Manual Del Operador

Tabla de contenido

Publicidad

NSR83-21HD
14
OPERATING THE NAILER

TESTING THE NAILER

1
1
• Disconnect air hose from nailer.
2
• Remove all nails from nailer.
• Loose screws on tool must be tightened before
use.
THE SAFETY/PUSH LEVER AND TRIGGER
MUST MOVE SMOOTHLY.
• Adjust the air pressure to 70psi.
• Connect the air hose.
• Do not load any nails in the nailer.
2
THE NAILER MUST NOT LEAK.
• Remove finger from the trigger and press the
safety/push lever against the wood.
THE NAILER MUST NOT OPERATE.
• Separate the safety/push lever from the wood.
• Next, point the nailer in a safe position, pull the
trigger and then hold that position for 5 seconds
or longer.
3
THE NAILER MUST NOT OPERATE.
• Without touching the trigger, depress the safety/
push lever against the work piece.
3
• Pull the trigger.
• Hold the trigger back while separating the safety/
4
push lever from the wood.
• Remove finger from the trigger.
NAILER OPERATION WILL END (the driver
4
blade will return to the top).
• With the nailer off the work piece, pull the trigger.
• Depress the safety/push lever against the work
piece.
THE NAILER MUST OPERATE IF SET IN
5
5
BUMP FIRE MODE.
Interchange Brands Framing Nailers: Operator's Manual

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

65720

Tabla de contenido