Publicidad
Idiomas disponibles
Idiomas disponibles
Technical data
Handle weight
Head weight
Number of strokes
Lead battery power supply
Consumption
Motor power
Shell material
Motor
Degree of protection of the power unit
Unless otherwise specified, the machine is intended for use under the following conditions:
➢ Below 1000m above sea level.
➢ Ambient temperature between 5°C and + 45°C. (24-hour average <= at 35°C)
➢ Relative humidity 30% to 85% without condensation.
➢ Material temperature < 45° C.
Command, control and safety devices
•
Electrical cut-off device, fuse (3) with max. motor absorption limit 15 A.
Storage
The packaged product can normally be stored in a closed environment as long as the temperature is not lower than -
20 °C or higher than +50 °C and the humidity does not exceed 70 %.
No other packages must be placed on top of the packaging.
Special care must be taken for fragile materials.
Follow the position indications marked on the packaging.
Special care must be taken during loading, unloading, transport, so as to avoid shocks.
Make sure that the packaging has not been damaged during these operations.
No damaged packaging shall be repaired by the customer.
CAUTION!
It should be remembered that certain effects resulting from the exposure of a product to environmental conditions are
the direct consequence of its exposure in sequence to two or more factors or parameters, among which are particularly
critical:
➢
,
thermal shock
which may result from exposing the product to high temperature conditions immediately after
exposure to low temperature conditions or vice versa, or subjecting the product to water (rain, water jets, snow,
immersion, etc.) immediately after exposure to high temperature conditions
➢
the formation of ice
before or after exposure to moisture, rain or water due to causes other than rain
CAUTION!
After storing the product within the limits of the above-mentioned conditions, it is required that it be kept in non-opera-
tive condition for approximately 12 hours in order to re-establish the correct ambient temperature conditions permitted
(see paragraph 3.6) so as to avoid damage to the electrical/electronic part as a result of thermal shock, ice formation
or humidity, etc., which may deteriorate or damage these circuits.
NOTE: any conditions other than the above may be indicated in the component-specific and accompanying documen-
tation. In this case, the instructions in the specific documentation must be followed
Page 38
Technical data
,
which may result from exposing the product to below-freezing temperatures immediately
280 g
1,420 g
1,200 ± 5 rpm
12V
7-8 Ah
325 W
Thermoplastic
Motor with brushes
IP 00
0310.0419 Use and maintenance manual – Instructions
Translation of the Original instructions Rev.: 00, Date 22/06/2023
;
.
.
Publicidad
