Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Operating instructions
6. Fitting the Adaptor System & MBX
Disconnect the tool from the power supply before changing the belt or Adaptor
System. The machine must be switched off and the spindle at a standstill.
6.1
Positioning the accessory
See Figure 6.
a)
Fasten MBX
(pay attention to rotation direction) and serrated lock washer and screw.
Figure 6
b)
Before plugging in to operate the tool, you must check that it is possible to actuate
the Safety Switch correctly and that the switch returns to the "OFF" position
c)
when you release the pressure on the Safety Switch. To start the tool, release the
safety clip by pushing it backwards and push the Safety Switch (Figure 7).
10
®
Belt or Vinyl Zapper
®
Belt correctly to the tool using the MontiPower
®
MBX
ULTIMATE ELECTRIC VARIOMATIC
®
®
Adaptor System
Publicidad
