Publicidad
Idiomas disponibles
Idiomas disponibles
®
MBX
ULTIMATE ELECTRIC VARIOMATIC
8. Cleaning
To clean the motor, hold the tool firmly
slots regularly and thoroughly, Figure 2.
9. Troubleshooting
Mains powered machines:
•
Overload protection: There is a MAJOR reduction in load speed.
too high! Allow the machine to run at idle speed until it has cooled down.
•
Overload protection: There is a SLIGHT reduction in load speed.
Reduce the load before continuing to work.
•
S-automatic safety shutdown: The machine was SWITCHED OFF automatically.
•
If the slew rate of the current is too high (for example, if the machine suddenly seizes or
kickback occurs), the machine switches off. Release the Safety Switch to switch off the
machine. Switch it on again and continue to work as normal.
•
Machine is running but MBX
damaged and needs to be replaced. See chapter 11, Repairs.
•
Machine is running but no or limited roughness is created.
Belt onto the object is incorrect, or the MBX
10. Accessories
Use only genuine MontiPower
Use only accessories listed in these operating instructions or expressly approved by the
manufacturer. For a complete range of accessories, see
11. Repairs
Repairs to electrical tools must be carried out by qualified electricians ONLY! Contact
your local MontiPower
repairs.
You can download specific repair instructions and a list of spares and assemblies from
www.montipower.com.
12. Environmental Protection
The dust generated by the MBX
dispose dust with household waste, but only at collection points specifically
designated for hazardous waste.
Observe national regulations on environmentally compatible disposal and on the recycling of
machines, packaging and accessories. Never dispose of power tools and or batteries in your
household waste! In accordance with European Directive 2012/19/EU on waste electrical and
electronic equipment (WEEE) and its implementation in national legal systems, used power
tools must be collected separately and handed in for environmentally compatible recycling.
and blow compressed air through the rear ventilation
®
Belt does not rotate.
®
accessories.
®
representative if you have MontiPower
®
process may contain hazardous materials. Do not
The toothbelt is broken or heavily
The positioning of the MBX
®
Belt is worn out and needs to be replaced.
www.montipower.com.
The motor temperature is
The tool is overloaded.
®
power tools requiring
EN
®
13
Publicidad
