GE AEH18 Serie Manual Del Propietario Y Instrucciones De Instalación página 5

Do Not Operate in Freezing Outdoor Conditions
This cool-only air conditioner was not designed for
fleezing outdoor conditions° It must not be used in
fleezing outdoor conditions.
ge.corn
Cool Mode
Use file
Cool mode at LOW,
Med, H_ghor AutoFan
Speed for cooling.
Use the
Temperature Increase A /
Decrease V pads to set the desired wmperamre
between 64°F and 86°F in ] °F increments.
AJ_ electronic dlemlostat
is used to maintain
file
room temperature. The compressor will cycle on
and
0_"
10 keep file room
at die
set level of comK>rt
Set die flleI]IIosta[ a a lower mmlber and die indoor
air will become cooler Set die dlerIllOStat at a higher
mmlber and die indoor air will become wamler
NOTE: ff theair conditioner i s offend is thenturnedon
whileset toa Coolsettingor if turnedfroma fansetting
toa Coolsetting,it maytakeapproximatdg 3 minutes
forthecompressor to startandcoolingtobegin.
Cooling Descriptions
For Normal Cooling--Select the COOl m ode and
High or Med fan with a middle set temperature.
ForMaximumCooling--Select die Coolmode
and Highfan widl a lower set temperature.
ForQuieter& NighttimeCooling--Select tile
Cool mode and LOW fan widl a middle set
temperature°
Energy Saver Mode
Controls the fan.
0N---The fan will cycle on and offwidl die
compressor This results in wider variations of room
mmpemmre and humidity: Normally used when the
room is unoccupied° NOTE: Thefan may continue to run
for a short time after the compressorcycles off
OFF--The fan runs all the time, while file
compressor cycles on and ore
Fan Only Mode
Use the Fan Only Mode at LOW,Med or High fan
speed to provide air circulation and filtering
without cooling° Nnce fan only settings do not
provide cooling, a Set temperature cannot be
enmred. The room mmpemmre will appear
in the display°
NOTE: AutoFanSpeed cannot b e usedwhenin the
Fan OnlyMode.
Auto Fan Speed
Set to Auto fan speed for the fan speed to
automatically set to the speed needed to provide
optimum comfort settings with the set tempelamre.
If die room needs more cooling, die fan speed
will automatically increase,
ff the room needs
less
cooling, the fan speed will automatically decre_kse.
NOTE: AutoFanSpeed cannot b e usedwhenin the
Fan OnlyMode.
Power Outage Recovery Feature
In die case of a power outage or interruption, file
unit will automatically re-start in the settings last
used after the power is restored. If the Belay
1-24hr
fe.amre was set, it will resmne cotmtdown. You may
need to set a new time if desired.
Remote Control
To ensure proper operation, aim file remote
control at tile signN receiver on the air
conditioner
Tile remote control signal has a range of
up to 20 feet
Make sure nodling is between file oh conditioner
and tile remora conUol that coukt block the
signN.
Make sure batteries are flesh and installed
correcdy _ksindicated on the remora control.
5