Additional controls,
ge.com
Vent Control
The
vent
control
is located
above
tlle
control
panels.
When
set at CLOSE, only the
air inside
the
room
will be circulated
and
conditioned.
When
se[ at
OPEN, some outside air is let into the room.
To open the vent, push the lever to the right,
To close it, push it to the left.
Air Direction--Up
and Down
Fingertip pressure on tile horizontal louvers
adjusts tile air direction up or down.
Control Panel Door
Press to open and close tile door
NOTE: Tile remote conaol
(on some models) will
work with tile conuol panel door open or closed.
Normal operatingsounds.
You may hear a pinging
noise caused by
water being picked
up and fluown
against file
condenser
on rainy days or when die humidiD_
is high. This design feature
helps remove
moisture
and improve
efficiency.
You may hear die thermostat
click when die
compressor cycles on and (fie
Water will collect in die base pan during
high humidity or on rainy days. Tile wamr may
overflow and drip flom the outdoor side of
the unit.
Tile fan may run even when
die compressor
does not.