Scheppach DP18VARIO Traduccion Del Manual De Instrucciones Originale página 29

• 13 mm Allen key
• 14 mm Allen key
• 1 Hexagon spanner
• 1 Drift wedge
• 1 Chuck
• 1 Column
• 1 Machine foot
• 1 Crank handle
• 1 Tapered mandrel
• • 1 Drilling table holder 1 Drilling table holder
• 1 Roller support
• 1 Operating manual
4. Proper use
The bench drill is designed for drilling in metal, wood,
plastic and tiles. Straight shank drills with a drilling
diameter of 3 mm to 16 mm can be used.
The device is only intended to be used for DIY purpos-
es. It was not designed for continuous commercial use.
The device is not intended for use by people under the
age of 16. Children under the age of 16 may only use
the device when supervised. The manufacturer is not
liable for damage caused by improper use or incorrect
operation.
It is strictly forbidden to dismantle, modify or
change the purpose of the guards on the machine
or to fit other guards.
Please note that our equipment was not designed with
the intention of use for commercial or industrial purpos-
es. We assume no guarantee if the device is used in
commercial or industrial applications, or for equivalent
work.
5. Safety instructions
m WARNING - Read all safety information, instruc-
tions, illustrations and technical data for this elec-
tric tool.
Failure to follow all instructions listed below may result
in electric shock, fire and/or serious injury.
Save all warnings and instructions for future ref-
erence.
The term "electric tool" used in the safety instructions
refers to mains-powered electrical tools (with a mains
cable) and battery-powered electrical tools (without a
mains cable).
Work area safety
a. Keep your work area clean and well-lit.
Cluttered or dark areas invite accidents.
b. Do not operate power tools in explosive at-
mospheres, such as in the presence of flam-
mable liquids, gases or dust.
Power tools create sparks which may ignite the
dust or fumes.
c. Keep children and bystanders away while op-
erating a power tool.
Distractions can cause you to lose control.
Electrical safety
a. Power tool plugs must match the outlet.
Never modify the plug in any way. Do not use any
adapter plugs with earthed (grounded) power
tools. Unmodified plugs and matching outlets will
reduce risk of electric shock.
b. Avoid body contact with earthed surfaces,
such as pipes, heaters, ovens and refriger-
ators. There is an increased risk of electric
shock if your body is earthed or grounded.
c. Do not expose power tools to rain or wet con-
ditions.
Water entering a power tool will increase the risk
of electric shock.
Do not use the cable for another purpose, for
d.
example, carrying or hanging the electric tool
or pulling the plug out of the socket.
Keep the cable away from heat, oil, sharp edges
or moving device parts. Damaged or coiled cables
increase the risk of an electric shock.
e. If you work with an electric tool outdoors, only
use extension cables that are also suitable for
outdoor use.
Using an extension cable suitable for outdoor use
reduces the risk of an electric shock.
Only use approved and appropriately identified ex-
tension cables for use outdoors. Only use cable
reels in the unrolled state.
If operating a power tool in a damp loca-
f.
tion is unavoidable, use a residual current
circuit breaker with a trigger current of
30 mA or less to protect the power supply.
Using a fault-current circuit breaker reduces the
risk of an electric shock.
www.scheppach.com GB | 29