Scheppach DP18VARIO Traduccion Del Manual De Instrucciones Originale página 36

Countersinking and centre drilling
With this bench drill you can also countersink or pilot
drill. Note that countersinking must be performed at the
lowest speed while a high speed is required for centre
drilling.
Machining wood
Note that suitable dust extraction must be used when
machining wood, as wood dust can be harmful to
health. Wear a suitable dust protection mask when
performing work that generates dust.
Metalworking
When drilling metals, use a suitable cooling lubricant to re-
duce wear of the tool and heat build-up in the workpiece.
ATTENTION! Avoid skin contact and wear safety gog-
gles!
11. Electrical connection
The electrical motor installed is connected and
ready for operation. The connection complies with
the applicable VDE and DIN provisions. The custom-
er's mains connection as well as the extension ca-
ble used must also comply with these regulations.
When working with this electric tool and during tem-
porary use outdoors, the device must be connected
to a residual current circuit breaker with a trigger
current of 30 mA or less.
Important information
In the event of overloading, the motor will switch itself
off. After a cool-down period (time varies) the motor
can be switched back on again.
Damaged electrical connection cable
The insulation on electrical connection cables is of-
ten damaged.
This may have the following causes:
• Pressure points, where connection cables are
passed through windows or doors.
• Kinks where the connection cable has been improp-
erly fastened or routed.
• Places where the connection cables have been cut
due to being driven over.
• Insulation damage due to being ripped out of the wall
outlet.
• Cracks due to the insulation ageing.
36 | GB
Such damaged electrical connection cables must not
be used and are life-threatening due to the insulation
damage.
Check the electrical connection cables for damage
regularly. Ensure that the connection cables are dis-
connected from electrical power when checking for
damage.
Electrical connection cables must comply with the ap-
plicable VDE and DIN provisions. Only use connection
cables with the designation H05VV-F.
The printing of the type designation on the connection
cable is mandatory.
Connection type X
If the mains connection cable of this device is dam-
aged, it must be replaced with a special connection
lead available from the manufacturer or its after-sales
service.
AC motor
• The mains voltage must be 230 V~.
• Extension cables up to 25 m long must have a
cross-section of 1.5 mm2.
Connections and repair work on the electrical equip-
ment may only be carried out by electricians.
Please provide the following information in the event
of any enquiries:
• Type of current for the motor
• Machine data - type plate
• Engine data - type plate
12. Cleaning and maintenance
Pull out the mains plug before carrying out any
adjustments, maintenance or repair work!
m Have maintenance and repair tasks that are not
described in this operating manual, carried out
by our service centre. Use only original parts. Let
the device cool down before all maintenance and
cleaning tasks. There is a risk of burns!
Each time before using the device, check it for obvi-
ous defects such as loose, worn or damaged parts,
or that screws or other parts are tight. Replace dam-
aged parts.
www.scheppach.com