12.
Technical Specifications
• Internally powered equipment
• Not suitable for use in the presence of flammable anesthetic mixtures with air, oxygen or
nitrous oxide
• Continuous operation
• Ingress of liquids – not protected
• The device is intended for indoor use only
• Environmental conditions during storage/transportation:
▪
Temperature: –20 ºC to +60 ºC (-4 ºF to 140 ºF)
▪
Relative humidity: 10% to 90%, non-condensing
▪
Atmospheric pressure: 106 kPa to 19 kPa
• Environmental conditions during device usage:
▪
Temperature: +10 ºC to +40 ºC (50 ºF to 104 ºF)
▪
Relative humidity: 10% to 90%, non-condensing
▪
Atmospheric pressure: 106 kPa to 70 kPa
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult an authorized dealer or service representative for help.
Specifications:
Dimensions:
Weight:
Type of display:
Power source:
External charger:
110 x 195 x 9 mm
260 gr.
7" IPS 1024x600
3450mAh Lithium-ion polymer battery
Input: 230V / 50-60 Hz or 120 V / 50-60 Hz
Output: 5V DC
- 23 -