auronic AU3165 Manual De Instrucciones página 30

4. TROUBLESHOOTING
Problem
The product no
longer works.
Water removal
capacity is too low.
Product works but
does not reduce
relative humidity
sufficiently.
Warm air is coming
out of the product.
Display does not
show humidity set
point.
Water on the floor.
The product makes a
lot of noise.
Contact the supplier if you encounter one or more of the error message(s) below.
30
Cause
The cable is not plugged in.
The water tank is full.
The water tank is incorrectly
positioned.
Run time is too short.
Ambient temperature or humidity
is too low.
Ambient space is too large.
There is too much ventilation at
that time.
The air filter is clogged.
The entered humidity level is higher
than the ambient temperature.
The dried air is passed over
heating coils before being blown
into the room as part of the
dehumidification process.
The display shows the ambient
humidity, not the humidity set at
the set point.
There is residual water in the water
tank.
The air filter is blocked, or the
product is not on a level surface.
Solution
Plug in the power cord.
Empty the water tank.
Reinstall the water tank.
Be patient, and wait a while
longer.
It is common for the product
not to work in these conditions.
It is recommended that you
look for a dehumidifier with a
longer range.
Make sure you ventilate the
room less.
Clean the air filter.
Set the entered humidity
level lower than the ambient
temperature.
This is completely normal,
nothing is wrong.
Press the humidity knob to
reset the desired humidity level.
Be careful when moving the
water tank.
Clean the air filter or place the
product on a flat surface.