auronic AU3165 Manual De Instrucciones página 31

Error code Error message
Temperature sensor
E1
error message.
Humidity sensor error
E2
message.
The product is in a
L4
room that is too cold.
5. MAINTENANCE AND CLEANING
1. Turn the product off and unplug the power cord.
2. Clean the casing with a soft, dry cloth. If the product is very dirty, use a mild detergent.
3. Wipe the product with a slightly damp cloth. Never spray the product with water. Do not use
aggressive or chemical cleaning agents. Do not immerse the product in water or hold the
product or parts of the product under running water.
4. Remove the filter and clean the filter with a vacuum cleaner or soapy water no hotter than
40°C.
5. Rinse and dry the filter completely before replacing it in the product.
6. STORAGE
Store the product in a clean and dry place. Do not store the product in extreme high or extreme
low temperatures.
7. DISPOSAL AND RECYCLE
Think about the environment and contribute to a cleaner living environment! This product is
subject to the European Directive (EU) 2012/19/EU. At the end of its service life, do not dispose of
the product with normal household waste, but deliver it to a collection point designated by the
authorities for recycling.
Display
Flashes on screen every
30 seconds.
Flashes every 30
seconds in picture.
Flashes every 30
seconds in picture.
English
Cause
Product is still
dehumidifying air while in
defrost mode.
Product is still
dehumidifying
while in continuous
dehumidification mode.
Make sure the room is at
least 2˚C warmer. After
±10 minutes, the product
starts working again.
31