Publicidad
Idiomas disponibles
Idiomas disponibles
TABLAS · TABLES · TABELAS ·
The touch
controls are
difficult to
operate.
The glass is being
scratched.
Some pans make
crackling or
clicking noises.
The hob makes
a low humming
noise when used
on
a high heat
setting.
Fan noise coming
from the hob.
Pans do not
become hot and
appears in the
display.
The hob or a
cooking zone has
turned itself off
unexpectedly, a
tone sounds and
an error code is
displayed
(typically
alternating with
one or two digits
in the cooking
timer display).
Problema
16
•
There may be a slight film
of water over the controls or
you may be using the tip of
your finger when touching the
controls.
•
Rough-edged cookware.
•
Unsuitable, abrasive scourer or
cleaning products being used.
•
This may be caused by the
construction of your cookware
(layers
of
different
vibrating differently).
•
This
is
caused
technology of the hob.
•
A cooling fan built into your
induction hob has come on to
prevent the electronics from
overheating. It may continue
to run even after you've turned
the hob off.
•
The hob cannot detect the pan
because it is not suitable for
this hob technology.
•
The hob cannot detect the pan
because it is too small for the
cooking zone or not properly
centred on it.
•
Technical fault.
Causas Possíveis
Make sure the touch control area is dry and
use the ball of your finger when touching the
controls.
Use cookware with flat and smooth bases. See
'Choosing the right cookware'.
See 'Care and cleaning'.
This is normal for cookware and
does not indicate a fault.
metals
by
the
This is normal, but the noise should quieten
down or disappear completely when you
decrease the heat setting.
This is normal and needs no action. Do not
switch the power to the hob off at the wall
while the fan is running.
Use cookware suitable for this hob techlogy.
See section 'Choosing the right cookware'.
Centre the pan and make sure that its base
matches the size of the cooking zone.
Please note down the error
letters and numbers, switch
the power to the hob
off at the wall, and contact a
qualified technician.
O que fazer
Publicidad
