Publicidad
TROUBLESHOOTING
PROBLEMS
POSSIBLE CAUSES
The dishes and
glasses are blue
The rinse aid dosage is excessive.
streaked or have a
bluish tinge.
The salt level is too low.
The adjustment of the water hardness is not
The dishes and
adequate.
glasses show calci-
The cap of the salt reservoir is not properly
nation or a whitish
closed.
film.
The rinse aid is used up or the dosage is insuf-
ficient.
Racks are not fit to the end.
The door doesn't
lock.
The door is not lock.
Policies, standard documentation, ordering of spare parts and additional product
information can be found by:
• Visiting our website docs.whirlpool.eu and parts-selfservice.whirlpool.com
• Using QR Code
• Alternatively, contact our After-sales Service (See phone number in the warranty booklet).
When contacting our After-sales Service, please state the codes provided on your product's
identification plate.
The model information can be retrieved using the QR-Code reported in the energy label.
The label also includes the model identifier that can be used to consult the portal of the registry
at https://eprel.ec.europa.eu
SOLUTIONS
Adjust the dosage rates below.
Fill the salt reservoir (see FILLING THE SALT RESERVOIR).
Increase the values (see WATER HARDNESS TABLE).
Check to have properly closed the salt reservoir cap.
Add the rinse aid or adjust the dosage levels higher.
Verify that racks are fit to the end.
Vigorously push the door until you hear the "clack" sound.
EN
IEC 436
:
11
Publicidad
