Defiant 17000069 Guía Para El Uso Y Cuidado página 10

Troubleshooting (continued)
Problem
The lights are constantly on.
The lights flash on and off.
FCC RESPONSIBLE PARTY
Globe Electric
2264 East 6th Street
San Bernardino, CA 92410
www.globe-electric.com
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
CAN ICES-005 (B)/NMB-005 (B)
Possible Cause
□
The motion sensor may be picking up
a heat source like an air vent, dryer
vent, or brightly painted, heat-reflective
surface.
□
The motion sensor is in manual mode.
□
The motion sensor is wired through a
dimmer or timer.
□
The motion sensor is on the same
circuit as a motor, transformer, or
fluorescent bulb.
□
Heat or light from the bulbs may be
turning the motion sensor on and off.
□
Heat is being reflected from other
objects and may be turning the motion
sensor on and off.
□
The motion sensor is in "TEST" mode
and warming up.
10
Solution
□
Decrease the "SENS"
setting or reposition the
motion sensor.
□
Switch the motion sensor
to auto. See Using Manual
Mode on page 8.
□
Do not use a dimmer or
timer to control the motion
sensor. Replace the dimmer
or timer with a standard on/
off wall switch.
□
Install the motion sensor
on a circuit without motors,
transformers, or fluorescent
bulbs.
□
Reposition the bulbs away
from the motion sensor.
□
Reposition the motion
sensor.
□
Flashing is normal under
these conditions.