Publicidad
Idiomas disponibles
Idiomas disponibles
Operation (continued)
3
Adjusting the Motion Sensor
Detection Zone
□
Turn on the circuit breaker or fuse and the light
switch.
□
Perform a "walk test". Walk in an arc across
the front of the motion sensor (A).
□
Watch the light. The light will come on and the
red LED will flash indicating motion has been
detected.
□
Stop, wait for the light to turn off, and then
begin walking again.
□
Continue this process until the detection zone
has been established.
□
Adjust the sensor up, down, or side to side to
change the motion sensor (A) detection zone.
5
Adjusting the ON-TIME Switch
The "ON-TIME" switch determines the amount of time
the light will stay on full bright after all motion has
stopped.
□
Set the "ON-TIME" switch to the 1, 5, or 20
minute position.
A
4
Adjusting the SENS Dial
□
To increase the detection zone, turn the
"SENS" dial toward the "HIGH" position.
□
To decrease the detection zone, turn the
"SENS" dial toward the "LOW" position.
NOTE: The motion sensor is more sensitive to motion
moving across the front of the sensor. The motion sensor
is less sensitive to motion moving directly toward the front
of the sensor.
NOTE: The higher the "SENS" setting (sensitivity), the
greater the possibility of false triggering. To reduce false
triggering, rotate the "SENS" control toward the "LOW"
setting.
6
Adjusting the DUALBRITE
Switch
The "DUALBRITE" switch determines the amount of time the lights stay
on at a reduced light level after sundown. Switching this setting to "OFF"
will not effect the "ON-TIME" setting.
Setting DualBrite to OFF will not allow the DualBrite feature to work
but the motion sensor will still turn on the light when motion present at
night time.
□
Set to 6 hours to have low level ambient light for 6 hours after
dusk starts when there is no motion present. Feature will
inactivate after 6 hours or if sunrise comes first
□
DualBrite will allow the low level ambient light to stay on until
motion is detected then the light will go FULL BRIGHT until
no motion is detected and the low level ambient light will be
re-activated
7
Please contact 1-866-308-3976 for further assistance.
HOMEDEPOT.com
Publicidad
