Descargar Imprimir esta página

Defiant 17000069 Guía Para El Uso Y Cuidado página 6

Publicidad

Idiomas disponibles

Idiomas disponibles

Operation
1
Adjusting the Motion Sensor
CAUTION: Keep the motion sensor at least 1 in. (25 mm)
away from standard PAR38 bulbs.
CAUTION: Keep the motion sensor at least 2 in. (50 mm)
away from halogen bulbs.
CAUTION: To avoid water damage and risk of electrical
shock, the motion sensor controls must be facing the
ground when installation is complete.
Turn the power on at the circuit breaker or fuse
and turn on the wall switch.
Loosen the lock nut (3) and screw (4) to adjust
the motion sensor (A) for the desired coverage.
Rotate the motion sensor (A) so the controls
face toward the ground.
Raise the motion sensor (A) to increase the
detection distance.
Lower the motion sensor (A) to decrease the
detection distance.
Tighten the lock nut (3) and screw (4).
2
Setting the Sensor for Testing
When the "ON-TIME" switch is set to the "TEST"
position, the light fixture will operate during the day
or night. The light will stay on for 5 seconds after all
motion is stopped.
Set the "ON-TIME" switch to the "TEST"
position.
Set the "DUALBRITE" switch to the "OFF"
position.
Turn the "SENS" dial to the "HIGH" position.
Aim the motion sensor (A) in the general
direction of the area to be covered.
NOTICE: All clearances must be maintained. See Safety Information
on page 2.
3
A
NOTE: The motion sensor will need to completely warm
up (approximately 90 seconds) before beginning the setup
process.
6
4
A
A

Publicidad

loading

Este manual también es adecuado para:

1700007110092620981009262103