Publicidad
Idiomas disponibles
Idiomas disponibles
4.
COMPLETE INSTALLATION
Seal around the valving and
outlets with silicone sealant or
plumbers putty.
Install the faucet and drain
trim according to the
manufacturer's instructions.
Install any extra grab bars or
towel bars to the bridging
previously installed. Follow the
accessory manufacturer's
instructions.
Install the shower door
according to the manufacturer's
instructions.
CLEAN-UP AFTER
5.
INSTALLATION
When cleaning up after
installation, do not use
abrasive cleansers as they
may scratch and dull the
surface. Use warm water and
a liquid, non-abrasive
detergent to clean the surface.
Remove stubborn stains,
paint, or tar with turpentine
or paint thinner.
Kohler Co., Kohler, WI U.S.A.
Do not allow cleaners
containing petroleum
distillates to remain in contact
with the module surface for
any length of time.
Remove plaster by scraping with a
wood edge. Do not use metal or
wire tools. Use a powder-type
detergent on a damp cloth to
provide mild abrasive action to the
residual plaster.
9
A
1010410-2-
Publicidad
