Braun Silk-epil 9 SES 9 Manual Del Usuario página 8

Important
• This appliance is intended for house-
hold use only.
• For hygienic reasons, do not share this
appliance with other persons.
• When switched on, the appliance must
never come in contact with the hair on
your head, eyelashes, ribbons, etc. to
prevent any danger of injury as well as
to prevent blockage or damage to the
appliance.
• Do not use on warts or piercings.
Description
1a Massage roller cap
1b Skin contact cap*
2 Epilation head
3 SmartLight
4 Power button
5 Mode button
6 Charging light
7 Release button
8 Power supply
9 Shaver head*
9a Shaver foil unit*
9b Trimmer comb* (3 mm)
10 Massage pad*
11 Exfoliation brush with protection cap*
12 Brush adapter*
* not with all models
How to replace heads
Turn off the appliance, press the release
button (7) and take off the head. Click-on
a different one.
Charging
Before use, charge the appliance for
2 hours using the power supply (8).
Charging light (6)
Flashing white: charging in progress
White for 5 seconds: fully charged
Yellow: approx. 15 min charge left
Flashing yellow: please recharge
Operation time is up to 50 minutes when
used within 24 hours after charging.
8
Recharge when the yellow charging light
comes on or when the motor has stopped
completely. A 15-minute quick charge will
provide 10 minutes operation time.
The best temperature range for charging,
using and storing the appliance is
between 59 °F and 95 °F. Beyond this
range, charging might take longer.
The built-in rechargeable battery can
only be replaced by an authorized Braun
Service center.
Operation modes
start on Power mode (I).
Repeatedly push the mode button (5) to
select the following modes one after the
other:
Gentle mode (II)
Smart Touch mode
(A = automatic)
return to Power mode (I)
Smart Touch allows controlling the speed
depending on the pressure applied:
Light pressure:
Normal pressure:
Power and Gentle modes are available
with all attachments. Smart Touch has
been optimized for the massage roller
cap.
A red warning light (3) signals that you
apply too much pressure.
Travel lock (D)
To activate the travel lock, press the
power button 3 seconds until a beep
confirms successful activation. To unlock
the device, press the power button again
3 seconds. Release the power button,
when the appliance starts running.
Unlocking can also be done via charging.
Gentle mode for
sensitive areas
Power mode for
best efficiency