Preparing The Device For Use; Assembly - Solo 425 Comfort Manual Del Usario

3 Preparing the device for use

3 Preparing the device for use

3.1 Assembly

The backpack sprayer is dismantled before it is
dispatched. It must be fully reassembled again
before it is used.
Mounting of carrying system
(Model 425 Pro, 475 Pro), See Fig. 1 – Fig. 14
Installation of the pump lever:
See "Assembly Instruction of the pump lever"
Fig. 15 – Fig. 19
Fig. 15 Î Model 475 Comfort, 475 Pro:
The backpack sprayer is prepared at the factory for
left-hand side installation of the pump lever (facing
towards the tank inscription).
If you prefer the pump lever to be mounted on the
other side, reposition the safety clips (a) on the
opposite side.
The pump lever can be attached to either side of
the device. The figures show mounting on the left
(on the right, mounting is performed accordingly).
Fig. 16:
When fitting the pump lever, the retaining tube (b)
of the pump lever should be facing upwards and
back (facing towards the tank inscription).
Fig. 17 , Fig. 18:
1. Push washer onto the shaft
2. Push pump lever onto the shaft
3. Screw the pump lever to the shaft with screw
and washer, secure with nut.
Fig. 19:
The pump lever length can be adjusted in three
lengths. For this, depress the pin (i), move the
pump handle (c) and latch the pin (i) in one of the
three bores (j).
Fig. 20:
To put down the device, the pump lever can be
turned up with the pump handle (c) in the holder
pipe (b).
For work, turn the pump lever down again with the
pump handle (c) in the holder pipe (b).
Modell 425 Comfort, 475 Comfort, 425 Pro,
475 Pro:
Outside of work, the spraying tube (e) is attached
to the red carry handle (d).
ENGLISH 6
Fig. 21
Month/year of production
( schematic diagram / depending on the model )
a. safety bracket
(Model 475 Comfort, 475 Pro)
b. holder pipe
c. pump handle
d. carry handle (Model 425 Comfort,
475Comfort, 425 Pro, 475 Pro)
e. spraying tube
f. nozzle attachment
g. hand valve
h. pressure gauge (Model 425 Pro, 475 Pro)
Installation of the spray tube (e):
x Fasten the threaded collar (k) on straight and
firmly screw the spray tube with O-ring
(16x3 mm) hand-tight onto the shut-off valve (g).
Do not use any tools!
x Firmly screw the nozzle attachment (f) with the
O-Ring (10x2 mm) hand-tight onto the spray
tube. Do not use any tools!
x Model 425 Comfort, 435 Comfort, 475
Comfort:
Comfort:
Standard nozzle: flat-spray nozzle 04-F110, red,
order no.: 4074263
Alternative nozzle: hollow cone nozzle 1.4 mm Ø,
black, order no.: 4074755 + 4074756
h (only for
425 Pro,
475 Pro
a (only for
475 Comfort,
475 Pro)
Fig. 22 - Comfort