Descargar Imprimir esta página

KIKKA BOO NOA Instrucciones De Uso página 9

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 10
IMPORTANT! KEEP THESE INSTRUCTIONS FOR
EN
FUTURE REFERENCE.
• Never heat milk by boiling or using the microwave.
• Always check food temperature before feeding.
• Discard any milk that is left over.
Freshly expressed breast milk storage guidelines (for healthy term babies)
• Room temperature up to 25°C, up to 4 hours.
• Cooler with frozen ice packs -15°C to 4°C, up to 24 hours.
• Refrigerator 4°C, up to 3 days.
• Freezer -18°C to -20°C, up to 6 months.
Thawed breast milk storage guidelines (for healthy term babies)
• Room temperature up to 25°C, up to 2 hours.
• Cooler with frozen ice packs -15°C to 4°C, up to 2 hours.
• Refrigerator 4°C, up to 24 hours.
• Freezer NEVER REFREEZE thawed breast milk.
Breast milk left from a feeding:
Discard any milk that is leftover.
Baby feeding:
• Inspect the feeding nipple before each use and pull the feeding nipple in all directions. Throw away at the first signs of damage or weakness.
• Never dip the nipple in sweet substances or medication, your child may get tooth decay.
• Do not microwave. Do not heat the product in traditional ovens or on hot plates or open flames.
For your child's safety and health WARNING!
Continuous and prolonged sucking of fluids will cause tooth decay.
Always check food temperature before feeding.
Throw away at the first signs of damage or weakness.
Keep components not in use out of the reach of children.
Never attach to cords, ribbons, laces or loose parts of clothing. The child can be strangled.
Always use this product with adult supervision.
Never use feeding teats as a soother.
Tooth decay in young children can occur even when non-sweetened fluids are used. This can occur if the baby is allowed to use the bottle for long periods through the day and particularly through the night, when saliva flow
is reduced or if it is used as a soother.
Accidents have occurred when babies have been left alone with drinking equipment due to the baby falling or if the product has disassembled.
Troubleshooting:
Problem: I experience pain when I use the breast pump.
Solution 1: One of the reasons can be the too high vacuum level. Maybe you do not need the full vacuum power of the breast pump. At first use the massage mode as a massage stimulation and after that you can use the
pumping mode. If you still feel a pain, stop using the breast pump and consult your breastfeeding advisor.If the pump does not come away easily from the breast, it may be necessary to break the vacuum by placing a finger
between the breast and the silicone shield.
Solution 2: Use a hot towel to apply hot compress on breast and do massage with a little bit downward gesture, then do the pumping again.
Problem: The breast pump does not work.
Solution: Please, first check if you have assembled the breast pump correctly. To prevent interference keep other electric equipment, like mobile phone or laptop, away from the breast pump while expressing. Check the
battery and if needed charge it.
Problem: I do not feel any suction.
Solution: Check whether all breast pump connections are secure. Disassemble and assemble the pump (figure III; figure IV). Assembling your breast pump, make sure all pieces are clean and not damaged. While pumping,
make sure the breast shield is completely sealed around your breast.
Problem: There is milk overflow.
Solution: Turn off the breast pump. Disassemble the breast pump. Use a damp (not wet) cloth to wipe the breast pump. Clean other components according to clean and sanitize section. When all components are dry,
reassemble (figure IV).
Usage and storage conditions:
Keep the breast pump out of direct sunlight as prolonged exposure may cause discoloration. Store the breast pump and its accessories in a safe, clean and dry place without direct sunlight and away from heat sources. If the
appliance has been stored in a hot or cold environment, place it in the usage environment to let it reach a temperature within the usage conditions (10°C - 30°C) before you use it.
Technical specifications:
Sucking power: 6 – 43 kPa;
Noise limited: 50db;
Fixed time: 30 minutes;
Lithium battery: 3.7V, 1100mAh Li-ion;
Protection against electric shock: Class II;
Power in: 5V 1A, 110-240V 50-60Hz;
Environmental conditions for operation: temperature 5-40°C, relative humidity 10-90%, atmospheric pressure 50kPa~106kPa;
Environmental conditions for storage: temperature 5-40°C, relative humidity 10-90%, atmospheric pressure 50kPa~106kPa;
Adapter input: 110-240V 50~60Hz, output: 5V 1A 5.0W;
Capacity 150ml;
Size: 12x8x14.8 cm, main device weight 302g.
Complies with EN 55014, REACH Regulation, EN 61000, RoHS Directive. Produced for Kika Group Ltd. Made in China.
ENGLISH

Publicidad

loading