Publicidad
Idiomas disponibles
Idiomas disponibles
1,
2,
4,
5,
6,
7,
INS TA LLA TION
Run some water from the hot
and cold faucets to flush the
water
lines
and
remove
particles that might clog up the
water valve screens,
Remove the inlet hoses and
rubber
washers
from
the
plastic
bag and install
the
rubber washers
in each end
of the inlet hoses,
Carefully connect the inlet hose
(90 ° elbow end) marked "HOT"
to the outside "H" outlet of the
water valve, Tighten by hand, then
_}
tighten another
2/3 turn with pliers,
Carefully connect the other inlet hoseto the inside "C"
outlet of the water valve, Tighten by hand, then tighten
another 2/3 turn with pliers,Do not crossthreador
over-tighten
these connections.
Connect the inlet hose ends to the HOT and COLD water
faucets tightly by hand, then tighten another 2/3 turn with
pliers, Turn the water on and check for leaks,
NOTE: Use only new hoses,
Carefully move the washer to its final location,
NOTE: Do not use the dispenser drawer or door to lift
washer,
With the washer in its final position, place a level on top of
the washer, no rocking of the washer should exist,Acljust the
front leveling legs up or down to ensure the washer is resting
solid, Rear leg ac!justment is accessible through the front
servicepanel, Turn the lock nuts on each leg up towards the
baseof the washer and snug with a wrench,
NOTE:
Keep the leg extension at a minimum to prevent
excessive vibration, The farther out the legs are
extended the more the washer will vibrate,
Form a U shape on the end of the drain hose with the hose
pointed toward the drain, Placein a laundrytub or standpipe
and secure with the cable tie provided in the enclosure
package,
NOTE:
If the drain hose is placed in a standpipe without
forming a U shape, a siphoning action could occur,
There must be an air gap around the drain hose, A
snug hose fit can also cause a siphoning action,
\
\
Tie
8,
Plug the power cord into a grounded outlet,
NOTE:
Check to ensure the power is off at a circuit
breaker/fuse box before plugging the power
cord into an outlet,
9,
Turn on the power at a circuit breaker/fuse box,
10, Readthe Operating Instructions and Owner's Guide provided
with the washer, They contain valuable and helpful
information that will saveyou time and money,
11, Run the washer through a complete cycle, Check for water
leaks and proper operation,
12, If your washer does not operate,
please review the
"Avoid Service Checklist" in your Owner's Guide before
calling for service,
13, Place these instructions
in a location near the washer
for future reference,
NOTE:
A wiring diagram is located inside the washer on
the service panel,
REPLA CEMENT
PARTS
If replacement parts are needed for your washer, call
Sears Parts and Service Toll Free Number 1-800-4-MY-
HOME
TM
(1-800-469-4663),
Destroy the carton and plastic bags
after the washer is unpacked, Children might use them
for play, Cartons covered with rugs, bedspreads, or
plastic sheets can become airtight chambers causing
suffocation, Place all materials in a garbage container
or make materials inaccessible to children,
The instructions in this manual and all
other literature included with this washer are not meant
to cover every possible condition and situation that
may occur, Good safe practice and caution MUST be
applied when installing, operating and maintaining any
appliance,
Maximum
benefits and enjoyment
are achieved
when all the Safety and Operating instructions are
understood and practiced as a routine with your
laundering tasks,
Cable Tie
Cable
Tie
Publicidad
