Descargar Imprimir esta página

GE Zoneline 2800 Manual Del Propietario Y Instrucciones De Instalación página 18

Ocultar thumbs Ver también para Zoneline 2800:

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation
Instructions
INSTALLING THE ZONELINE
[] INSTALL THE WALL CASE AND
EXTERIOR GRILLE
The l_a,g71 series or I_B77
wall case must be
properly
installed
per instructions
packed
with
the case.
• Remoxe
the
corrugated
stiffener
and
the outdoor
protectixe
panel.
Use
the slit in the
outdoor
panel
as a handhold
and
push
out.
Pro
panel
Stiffenel
• Install the exterior
grille from the room side
following
instructions
packed
with the grille.
Insulated
Wall
Case
This unit is designed
to be installed
in a GE plastic
or an insulated
steel wall case. This minimizes
condensation
fl'om forming
on the room side of
the case,
The ]L_B7] series wall cases are insulated.
Insulation
kit ]LM(901 I, is available for use with ]L_B77 or
existing
uninsulated
wall cases when
needed.
NOTE:
For installation
with a subbase
or duct adapte_;
see the instructions
packed
with those kits.
[] PREPARE THE UNIT
• Carefully
remove
shipping
tape and loam shipping
bloc!cs from the room
cabinet,
compressor
and
vent doo_: There
may be multiple
blocks and pieces
ot shipping
tape that need
to be removed.
Shipping tape_
(Locations m ayvary)
• Remove
the room cabinet
b)pulling
it out at the
bottom
to release it (1), then lift it up to clear the
rail along the unit top (2).
O
• If vent
door
is to be operational,
remove
shipping
screws
fl'om
the fl'ont
side of the xent
(lo(m
if present.
Remove two
shipping screws
18

Publicidad

loading

Este manual también es adecuado para:

Zoneline 3800