About the controlson yourZoneline.
CEA..lia.cescom
/
TEMPCONTROL
0
MODECONTROL
@
Co trols
Temp Control
The temp
control
is used to maintain
the
I'00111
tell/pei'att/i'e.
The COlll[)i'essoi" will
c_cle on and off to kee I) the room at the
same comtort
level. _,_]_en w)u tm'n the
knob to
COOLER
(blue),
the indoor
air
will become
cooler. Tm'n the knob to
WARMER (red) and the indoor
air will
becollle
wa illlei
i
3800Series only
_,_]_en the outdoor
temperatm'e
is lower
than 20°E heat is provided
b)' the electric
heater
in the air conditioner
instead
of bv
the heat I)ump.
Mode Control
HIGH COOL and LOW COOLpr_Mde cooling
with different
tim speeds.
HIGHHEATand tOW HEATprovide
heating
with different
tim speeds.
LOWFAN or HIGH FAN provides air
circulation
and filtering
without
cooling
or heating.
NOTE: If you move the switch from a cool or heat
setting to STOP orto a fan setting, the unit has an
automatic 3-minute delay before allowing the
compressorto restart in the cool or heat mode.
About Your Heat Pump (3800 Series only)
Heat pmnps
can save money by removing
heat
fl'om the outside
air----even when
the outside
temperature
is below freezing--and
releasing
that heat indom_.
To get the best pet_kmnance
flxm_ ):ore" heat
l)ump,
don't change
the room them_ostat
ve_y
otten.
Raising the heat setting
2-3 degrees
will
cause the Zoneline
to use its electric
heating
elements
in order to reach
the new temperatm'e
setting
quickly.
There
is a three mimlte
minimum
compressor
run time at any setting
to prevent
shin* cycling.
The indoor
tim motor
starts befl)re
the
COllll)I'essoI"
and
stops
aJ[teI"
the
coI/ll)I'essoI"
cycles off.
The electric
heating
elements
use much
more
electricit_
than heat pmnps
and cost
II/OI'e
to
ol)erate.
3