Publicidad
Idiomas disponibles
Idiomas disponibles
[] Initial Setup_
This sectionwill guide youthrough the unit's initial setting which includes
selectinga languagefor youron-screenmenuandautoscan,which
automatically scansandmemorizesviewablechannels.
Before youbegin:
Make surethe unit isconnectedto antenna or cables.
_
After making
all the necessary connections,
press [POWER] to turn on the unit.
POWER
_
Use[Cursor _111_]to select the desired location setting,
then press [ENTER[.
or
. This operation
may take a few moments.
_
Use [Cursor AIr]
to select the on-screen
language
from the choices on the right side of the TV screen.
(English / Espaflol / Franqais)
or
, "Initial Setup" menu on step 3 will be displayed
in the
selected language
after you press [ENTER].
_
Use [Cursor AIr]
to select"Antenna"
for TV channels
or "Cable" for CATV channels,
then press [ENTER[.
or
. "Autoscan"will
begin.
C_
,zi!i:
ii _<,'i
Select "Retail", the unit will be set up with predefined
setting
for retail displays. In this setting, the power
:::
consumption
may possibly exceed the limited
::
requirement
of the ENERGY STAR® qualification.
Select "Home",
the unit is set to maximize
the energy
...........
efficiency
for home setting
and it can be adjusted
through
a choice of picture and sound quality
according
to your preference.
When the initial setup is completed,
the lowest
memorized
channel with the confirmation
message
of the location
setting
will be displayed
on the TV
screen.
Note:
• If you connect the cable system directly,
contact
the CATV
installer.
• If you press [POWER]
or [SETUP] during
autoscan,
this
setting
will be canceled.
• The initial
autoscan
function
can be executed
for either
"Antenna"
or "Cable" only once. When you change
the
connection
(Antenna
/ Cable), set autoscan
again.
(Refer to page 18.)
• If there is no signal input from the antenna
terminal
and
no operation
for several seconds after you turn on the unit,
"Helpful Hints" appears. Follow the instructions
listed on
the TV screen.
• You must set "Home"in
step 4. Otherwise,
the settings
of picture
and sound
quality you adjusted
will not be
memorized
after you turn off the unit.
!,;'iiii,i_
After an initial setup is completed...
, If you want to scan the channels automatically
again,
refer to "Autosca n" on page 18.
You can add the desired channels unmemorized
by
"Autoscan". Refer to "Manual
Register" on page 19.
If you want to change to another
language,
refer to
"Language
Selection"
on page 20.
If you want to change the location
setting,
refer to
"Location"
on page 31.
EN
Publicidad
