Num'axes PIE1067 Manual De Instrucciones página 28

Camera
status LED
3. Power supply
3.1. Batteries
The camera runs on 12 AA size batteries. The product can work with alkaline, lithium
or Ni-MH rechargeable batteries.
You can purchase alkaline or Ni-MH AA batteries at any time on www.numaxes.com.
Before inserting or removing the batteries, the camera must be turned off (switch
in the OFF position).
When inserting the batteries, make sure to follow polarities indicated inside the
battery compartment. Upside down batteries may cause device malfunction.
Please select the battery type you're using in the menu option "Battery type" to reach
longer operation time.
WARNING: Don't mix battery types! This may cause permanent damage not covered
by the guarantee.
Remove the batteries from the camera if you are not using it for 3 months or more.
The batteries could leak and damage your product.
3.2. Solar panel
This camera is able to work with a solar panel with build-in lithium battery (12V/2A).
You can purchase a 12V solar panel at any time on www.numaxes.com.
NOTE: the solar panel cannot charge Ni-MH batteries inserted in the battery
compartment of the device as these batteries require a higher voltage to recharge.
3.3. External power supply
This camera can also be powered by an external DC adapter (12V/2A).
You can purchase a 12V external DC adapter at any time on www.numaxes.com.
We recommend removing the batteries when a power adapter is used.
Flashes every
second
PIR triggers /

Take photo under
SETUP mode
Guide PIE1067 – Février 2024 – ind. A - 28/128
Flashes during
5 seconds then
goes out
Camera enters
into auto
working mode
ON
Camera in
SETUP mode