Num'axes PIE1067 Manual De Instrucciones página 39

Cycle recording on
memory card
8. Setting up the camera
− Mount the camera facing north or south, not east or west as the rising and setting
of the sun could produce false triggers and overexposed images.
− If you're covering a trail, face the camera down or up the trail.
− Clear out any brush or weeds in front of the camera. These can cause false
triggers due to temperature and motions disturbances in front of the camera
(especially in windy days).
− Check the power level of the batteries (AA and solar panel) before setting up the
device.
− Make sure the memory card is properly inserted and have sufficient available
space.
− Verify time and date are correct.
− Make sure to turn the camera ON (switch in the ON position).
9. Technical specifications
Image sensor
Infrared flash
Memory
Lens
PIR sensor
Capture modes
Resolution of photos
saved on the SD card
ON | OFF
When the memory card will be full, the camera will
continue to record photos/videos by deleting the
oldest photos/video.
Select OFF to deactivate the cycle recording
function.
3 Mega Pixels Colour CMOS
54 invisible IR LED | Wavelength: 940 nm
Infrared flash range: approx. 20 m (65 ft.)
SD card from 8GB up to 32GB maximum
(class 10 minimum)
F/NO = 2.0 | FOV = 60°
Adjustable sensitivity: High | Medium | Low
Detection distance: approx. 20 m (65 ft.)
Detection angle: 60°
Photo | Video | Photo + Video
12 MP (4800 x 2560) | 8 MP (3840 x 2112) |
5 MP (3072 x 1728)
Guide PIE1067 – Février 2024 – ind. A - 39/128