ECOFOREST VAP Serie Manual De Instalación Y Mantenimiento página 53


Stainless steel hose clamp.

T of 90° with outlet.

Wooden ground.

Non flammable floor protection.

Stainless steel flexible tube.

Rigid flexible pole adapter.

Minimum 200mm.

It must exceed roof height by 1 metre.
If the tube over 4 m in length, the next larger

size will be used.
To access the purgecock, we must remove the cap of the liner covering it and the safety thermostat. It is
located in the upper left side of the boiler. It is important to note that the purge should be performed by an
authorized installer.

Purger.
WI-FI ANTENNA CONNECTION, POWER CABLE, ROOM THERMOSTAT, KEYBOARD AND KEYBOARD SUPPORT.
The boiler is supplied with a Ecoforest box. This box contains the user manual, the installation and
maintenance manual, a power cable, a room sensor, a cleaning brush, a Wi-fi antenna.
The user has to attach the wi-fi antenna and module to the connection platform (check section 1 of the
tablet manual). The connection platform of the wi-fi antenna is supplied attached to the rear of the hopper.
The room sensor and power cable must be connected to the rear heaters, in the right-hand side of the boiler.

Power connection ~230/240V - 50Hz.

Thermostat connection.
HEATING SYSTEM DRAINING (VERY IMPORTANT).
52
Drawing 16




Drawing 14
Drawing 15


Drawing 17



