Broan QL130BC Instrucciones De Instalación página 3

PreParation
1. Use the dimensional drawings (refer to FiGures 1 - 3) to lay
out the range hood's mounting holes, wiring access and duc-
twork by marking the cabinet bottom and drywall where appli-
cable. NOTE: Cabinets with recessed bottoms will require wood
shims to make mounting surface flush with cabinet frame.
2. Make cutouts for wiring and ductwork.
3. If the hood is to be ducted, install the ductwork so that is flush
to the range hood's mounting surface.
refer to FiGure 1 if the range hood is to be installed with a
horizontal discharge.
refer to FiGure 2 and FiGure 3 if the range hood is to be
installed with a vertical discharge.
4. Run two-conductor wire (with ground) from a power source to
the hood location. Bring approximately 12" of wiring through
wiring hole in cabinet.
5. Drill four 3/32" diameter pilot holes at points where mounting
holes are marked in cabinet bottom.
6. Insert four (4) mounting screws, leaving approximately ¼" of
thread exposed.
7. Remove and retain the mounting screws securing the 3¼" x
10" and 7" duct transitions to the hood. Install the appropriate
duct transition as described in the installation section.
installation
1. Remove the necessary duct opening and wiring knockout from
the range hood.
if the range hood is to be installed as a non-ducted unit,
remove the wiring knockout only.
if the range hood is to be installed as a ducted unit, a baffle
plate is provided to close off the non-ducted vent. Install baffle
plate (refer to FiGure 4) by sliding into place behind grille.
Use locator bumps to orient in grille.
2. For 7" round discharge installation, refer to FiGure 5. Se-
cure 7" adapter (included) to top of hood using screws provided.
Install 7" round damper (Model BP87 (97010792), purchased
separately).
For 3¼" x 10" vertical discharge installation, refer to FiG-
ure 6. Secure 3¼" x 10" transition (if used) to top of hood.
For 3¼" x 10" horizontal discharge installation, refer to
FiGure 7. If using supplied 3¼" x 10" duct transition, secure
it to the range hood. Ensure that the damper flap operates
fully and freely. If it does not, remove the damper flap or make
necessary modifications to the installation to insure full and free
operation of the damper flap.
3. Feed the wiring through the access hold and into the electrical
box.
4. Align hood's keyhole mounting slots over the four (4) partially
installed screws.
5. Making sure the duct positions over the hood's duct transition,
push the hood against the rear wall. Secure hood by tightening
screws.
6. Using a long blade screwdriver, reach into the discharge open-
ing and make sure the damper flap operates freely (vertical
discharge only).
Get user manuals: See SafeManuals.com
locators
Position duct
transition in
Wall cutout
3
BaFFle
Plate
FiGure 4
7" round
adaPter
(included)
FiGure 5
secure transition
With screWs
(included)
FiGure 6
horiZontal
FiGure 7