Publicidad
Idiomas disponibles
Idiomas disponibles
• Do not plug heater into a circuit that already has
other appliances working. Heater draws 12.5 amps
during operation.
• To disconnect from power, first turn controls to
"OFF", then remove plug from outlet. Never pull by
the cord.
• Do not insert or allow foreign objects to enter any
ventilation or exhaust opening as this may cause
electric shock, fire or damage to heater.
• To prevent a possible fire, do not block air intakes
or exhaust in any manner. Do not use on soft
surfaces, such as a bed, where openings may
become blocked.
• Heater has hot and arcing or sparking parts inside.
Do not use in areas where gasoline, paint
or flammable liquids are used or stored.
Power Supply: AC 120V ~ 60 Hz
WARNING! Check the following before turning
on this heater.
• Ensure power cord is in good condition.
• Confirm power socket meets local requirements with
safe grounding and accomodates 120V AC power
supply.
PAGE 2 OF 9
SAFETY CONTINUED
MODEL
LOW
H-11322
900
• The output of this heater may vary, and its
temperature may become intense enough
to burn exposed skin. Use of this heater is not
recommended for persons with reduced sensitivity
to heat or an inability to react to avoid burns.
• Disposal of oil contained within this heater should
be in accordance with applicable local, regional
and national laws and regulations.
• Heater is hot when in use. To avoid burns,
do not let bare skin touch hot surface. If provided,
always use handles when moving this heater.
Keep combustible materials such as furniture,
pillows, bedding, paper, clothes and curtains at
least 3 feet from front of heater and away from
sides and rear.
SPECIFICATIONS
POWER REGULATION RANGE (WATTS)
HIGH
1,500
SETUP
LOCATION
Ensure heater is placed on a flat surface.
NOTE: Uneven surface may cause tip-over switch
to be in an abnormal position which will prevent
the heater from working after turning on.
LOW OSC
HIGH OSC
900
1,500
0124 IH-11322
Publicidad
