Costway NP10904 Manual Del Usuario página 6

Safety Warning: Assembly
1. Installation must be carried out by a competent adult.
2. Only suitable for soft soil, do not place it on concrete, asphalt,
wood or other hard surfaces. Carpeting hard floors may not
prevent injuries. Falling on hard surfaces can result in head or
other serious injuries.
3. Cannot be used for rental or commercial purposes. For family
use & outdoors use.
4. This product is heavy, please be careful when using it.
5. The product should not be dragged across concrete pavements
or other rough surfaces.
6. Keep the product away from fire and flames.
7. Do not install the product in windy or rainy conditions.
8. The slide should not face the sun as this can make children
dizzy while using the product.
9. Should be placed on flat ground, if placed on inclined ground
may occur toppling.
10. Place the product on a soft ground at least 2 meters away
from any other objects (such as fences, trees, water sources,
hanging branches, clotheslines or wires). Make sure that the area
around the product is safe. Check whether there are sharp
objects on the ground.
11. Electric wires must not be passed under the product.
12. Keep the blower (air pump) and power cord away from
children and water. Place the blower (air pump) where it will not
inhale dust or leaves.
13. Note: During use, the blower (air pump) should remain on and
continue to inflate. Since the product is kept inflated by a constant
air flow, air leakage from the joint is normal and necessary, so the
product will not over-expand.
10
Assembly Instruction
1. Unfold the product in its entirety as the picture shows.
Roll the
Take out the
product and
product
expand it
2. Place the blower (air pump) where it will not inhale dust or
leaves, and keep the blower (air pump) and power cord away
from children and water. Note: Please make sure that the power
supply is safe and reliable. During use, the blower (air pump)
should remain on and continue to inflate. After
stretching the air pipe, position the blower (air
pump) at the end of the air pipe. Wind one end
of the tube around the blower (air pump), blow
out the air after tying. The inflation tube
should be straight and not twisted. If
necessary, adjust the position of the blower
(air pump). Then use ground piles to firmly fix
the blower (air pump) on the ground.
3. Please fix the product correctly, and be sure to fix the product
with ground stakes before use. In order to prevent overturning
during the game, please push the pile firmly into the ground, and
regularly check whether the ground pile is firm. Ground piles
should be flush with the ground or buried in the ground to reduce
Fully expand
Open the
product the product
11