Standby Mode; Clock Mode - DELTACALOR Valet Manual De Usuario

Switching on for the first
time
When switching on the for the first time, or
after a lengthy power failure, the system au-
tomatically starts up in the DAY, HOUR and
MINUTE setting mode. If no day, hour and
minute setting is done, the system automat-
ically takes the setting to be DAY '1', HOUR
'00' and MINUTES '00'.
Changing the Day
This setting is done by selecting
Day changing will be visible in the side col-
umn of numbers (Monday =
, Wednesday = , ... , Sunday = ).
Confirm the selection by using
tion makes it possible to proceed with setting
the HOUR and MINUTES.
Changing the Hour and Minutes
This setting is done by selecting
the selection is confirmed using
HOUR and MINUTES can be set at a later
date using the 'tED' function (see p.27).
Stand-by mode
When in STAND-BY mode, only the
on the radiator is switched on. Push the
key to access all the system settings and func-
tions.
When switching from 'STAND-BY' to 'ON',
the last heating mode set will be reinstated,
whereas if 'IRONING' was used last, this will
not be reinstated.
After about 30 seconds of no activity, the
screen goes into energy saving mode. To reac-
tivate it, push any of the buttons on the lower
or .
strip on the screen.
, Tuesday =

Clock mode

. Confirma-
When in CLOCK MODE the radiator is
awaiting commands. From CLOCK MODE it
is possible to activate IRONING MODE (see
p.27) using the
er modes using the
or , and
Modalità manuale
. The DAY,
When the radiator is in MANUAL MODE,
the operating temperature can be set for the
AMBIENT coil.
This temperature can be set using the
and
the temperature set, will flash. Once the re-
quired temperature has been selected, wait
[ 25 - EN ]
button, or to go to oth-
key.
, keys, while the number that indicates
icon