Publicidad
Idiomas disponibles
Idiomas disponibles
Connect the outdoor antenna cable to booster connector marked as "outdoor". Tighten the
connection by hand or with a wrench.
Connect the indoor antenna cables to booster connector marked as "indoor". Tighten the
connection by hand or with a wrench.
Connect AC power cord to the signal booster, then connect the plug to the electrical
outlet to power on the booster. Note: the required booster mounting distance above the
floor is 1-1,8 m.
If it's necessary to install multiple indoor antennas solutions, please contact us. We will
provide you with a professional installation coverage plan.
Step 4. Booster Commissioning
Overview: The booster has an intelligent startup system; booster commissioning is an
automatic process able to guarantee system optimal performance.
As soon as you finish booster system installation, plug it in a power supply to power on the
booster. It will start working and checking the receiving signal strength and the isolation to
ensure best system performance. Automatic adjustment will take about 3-5 seconds.
After the booster starts, check if the coverage is improved as you wish. The booster
commissioning is completed.
In case the coverage is not enough, please check the following conditions.
The rated output power is reached, but the coverage is not enough or the signal in some
1.
areas are not improved:
Check whether the indoor antenna is installed correctly or not, try to change the
antenna position to improve coverage.
Check if it is necessary to adjust the direction of the indoor antenna.
Check whether it is necessary to add more indoor antennas since barriers block the
signal.
The rated output power is not reached.
2.
Change the position or direction of the outdoor antenna to get a stronger receiving
signal and higher output power.
coverage is enough).
(Not necessarily to reach rated value as long as the
14 / 19
Publicidad
