Descargar Imprimir esta página

GE PGP989 Manual Del Propietario E Instrucciones De Instalación página 14

Publicidad

Idiomas disponibles

Idiomas disponibles

Cleaning the glass cooktop.
/
/
The CERAMABRYTE ® Ceramic
Cool<top Scraper and all
recommended supplies are
available through our Parts Centen
See instructions under "To Order
Parts" section below.
NOTE: Do not use a dull or nicked
blade.
Heavy,
Burned-On
Residue
J-_ Allow the cooktop to cool.
[]
Remove the burner grates, vent grille
and vent grille gasket.
@
Use a single-edge razor blade scraper
at approximately a 45 ° angle against
the glass surface and scrape the soil. It
will be necessary to apply pressure to
the razor scraper in order to remove
the residue.
%
@
After scraping with the razor scraper,
spread a few drops of CERAIVlA B RYTE ®
Ceramic Cooktop Cleaner to the entire
burned residue area. Use the
CERAMABRYTE ® Cleaning Pad to
remove any remaining residue.
For additional protection, after all
residue has been removed, polish the
entire surface with CERAMABRYTE ®
Ceramic Cooktop Cleaner and a paper
towel.
Metal
Marks
and
Scratches
Be careful not to slide pots and pans across
your cooktop. It will leave metal markings on
the cooktop surface.
These marks are removable using
the CERAMABRYTE ®Ceramic Cooktop
Cleaner with the CERAMABRYTE ®Cleaning
Pad for Ceramic Cooktops.
WARNING: Carefully check the bottom
of pans for roughness that would scratch
the cooktop.
Glass surface--potential
for permanent damage.
Our testing shows that
if you are cooking high
sugar mixtures such as
jelly or fudge and have
a spillover, it can cause
permanent damage to the
glass surface unless the
spillover is immediately
removed.
Damage
from Sugary
Spills and Melted Plastic
J-f] Turn off all surface burners and, with an
oven mitt, remove hot pans and grates.
Wearing an oven mitt:
a. Use a single-edge razor blade
scraper (CERAMABRYTE ® Ceramic
Cooktop Scraper) to move the spill to
a cool area on the cooktop.
b. Remove the spill with
paper towels.
[]
Any remaining spillover should be left
until the surface of the cooktop has
cooled.
[]
Don't use the surface units again until
all of the residue has been completely
removed.
NOTE: If pitting or indentation in the glass
surface has already occurred, the cooktop
glass will have to be replaced.
In this case, service will be necessary.
14
To Order
Parts
To order CERAMABRYTE ®Ceramic Cooktop
Cleaner and the cooktop scraper, please call
our toll-free number:
National
Parts Center
800.626.2002
CERAMA BRYTE®
Ceramic Cooktop Cleaner..
# WX10X300
CERAMA BRYTE®
Ceramic Cooktop Scraper
# WX10X0302
Kit .......................
# WB64X5027
(Kit includes cream and razor scraper)
CERAMA BRYTE® Cleaning
Pads for
Ceramic Cooktops
.........
#W×!0×350

Publicidad

loading