GE PGP989 Manual Del Propietario E Instrucciones De Instalación página 16

Installation Instructions
UNPACKING YOUR COOKTOP
PARTS INCLUDED (PACKED BELOW THE COOKTOPI
, Blower assembly , Vent grille gasket , Burner cops
, Blower plenum , Cleaning cream (1 small, 2 medium, 1 large)
, (4) Nuts (10-32 keps- nuts with , Scrub sponge or scraper , Gas pressure regulator &
lock washers attached) (on some models) LP Conversion Instructions
, (9) Sheet metal screws , Burner grates , Attached 120-volt grounded
(8-18 x 3/8") , Burner heads plug cord
, Foam gasket tope (9-ft. roll) (1 small (A), 2 medium (B), , Reflective tape
, Vent grille 1 large (C))
, Vent filter
Check to be sure that all packing materials
and tape have been removed. This will include
tape on control knobs (if applicable), adhesive
tape, wire ties, cardboard and protective
plastic. Failure to remove these materials could
result in damage to the appliance once the
appliance has been turned on and surfaces
have heated. Reflective Tope
Cleaning Cream
Sheet Metal Screws (9)
(8-18 x 3/8"1
Burner Grate (2)
A CAUTION:
GLASS IS FRAGILE
DO NOT BUMP EDGE
OF GLASS DURING
INSTALLATION
Scrub Sponge / _" __
Regulator Vent Grille /
DoCNAUTTI L IFNT
Burner Caps and Burner Heads ,_ fRqM "/E KL
m_/ ",_ _
/©
BUMP GLASS
..rner Head
Burner Cap and Burner Head
Blower Assembly and (4)
Mounting Nuts (10-32 keps - nuts
with lock washers attached)
Foam Gasket Tape
Vent Grille Gasket
16
Blower Plenum Vent Filter