Maguisa ET-600 Instrucciones De Instalación Y Guía De Usuario página 25

Assembly:
1. Fixing the track bracket. Fixing the track bracket to the wall 2cm-15cm over the shaft or intermediate
bracket (depend on the actual installation space).
2. Fixing the steel track to the bracket with cotter pin A.
3. Fixing garage door opener to the track by U hanging bracket A. It's enough for 2 Nm fastening force.
4. Fixing the motor bracket. Fix the motor bracket as closer to the opener as you can, if there is enough
space. Notice: Make sure the track is horizontal and vertical to the shaft. Make sure the connection of iron
angle B and ceiling is firm enough.
5. Fixing the track by iron angle A and U bracket B.
6. The connection of panel bracket and and panel connector refer to the installation of aluminum track. Fix
the clutch cord.
7. Release the clutch, try to open and close the door by hand. Make sure there is no resistance between
door panel and track.
8. Connecting the opener with power and adjusting the operation.
Notice: Make sure the opener's voltage is in accordance with the local voltage; Connect the opener to a
properly earthed power supply.
25