Maguisa ET-600 Instrucciones De Instalación Y Guía De Usuario página 27

2. Matching the receiver and transmitter.
3. Safety reverse force adjustment.
4. Lock door.
Press 'CODE' button and hold on until the LED dot is on.
(Fig. A) Then press any button (except the lock button)
on the transmitter once, the dot will be off; press the
button again the dot will fast flash then LED displays '11'
(Fig. B). After that the transmitter will be available.
Press 'CODE' button more than 8 seconds until the LED
displays 'C', all the stored codes will be deleted
The transmitters of the box of the motor are ready to use.
Press 'SET' button and hold on until the LED displays
'3'. It's under force adjustment mode. Press 'UP' button
to increase the force and 'DOWN' button to decrease
the force. The maximum force is 9 and the minimum is
1. Press 'SET' button to confirm.
Press 'SET' button and hold on until the LED displays 4. It's
in lock door programming mode. Then press 'UP' botton, the
LED displays 1, the lock door function is available. Press
'DOWN' botton the LED displays 0, the lock function has
been turned off. Press 'SET' to confirm. You have to press
lock button then you can open the door 5 seconds later after
you close the door.
27