Manual Disengagement - Maguisa ET-600 Instrucciones De Instalación Y Guía De Usuario

Manual disengagement

The opener is equipped with a manual release cord to disengage shuttle and move door by hand while
holding the handle down. Pull on the handle to disengage the shuttle. To re-engage the door simply run
opener in automatic mode or move door by hand until the trolley engages in the chain shuttle.
In some situations that a pedestrian door is not in state, it is recommended that an external disengagement
device should be fitted.
Maintenance.
1. N No particular maintenance is required for the logic circuit board.
2. Check the door at least twice a year if it is properly balanced, and all working parts are in good
working condition or not.
3. Check the reversing sensitivity at least twice a year, and adjust if it is necessary.
4. Make sure that the safety devices are working effectively (photo beams, etc.).
1. Light bulb replacing. Make sure the power supply has been cut off before replacing the light hulb. And
ensure the voltage of the new light hulb is in accordance with the local voltage and the power is within
25 Watt. Demount the screws on the lamp cover. Take the lamp cover away then twist off the old light
bulbs anti-clockwise. Fix the new lamp hulb and lamp cover .
Notice: A rude operating door can affect the life of the automatic opener due to incorrect loads, and
will void the warranty.
31