Publicidad
Idiomas disponibles
Idiomas disponibles
10 Setting up and connecting
Before setting up and connecting the appliance, ensure that
•
the appliance is disconnected from the mains power supply (see safety chapter, →
Electric Shock) and
•
the installation conditions are fulfilled (see chapter Minimum Clearances).
Unpacking the appliance
The packaging materials must be undamaged. Inspect the appliance for transport
damage. On no account should a damaged appliance be connected to the mains power
supply. In case of damage, contact the supplier.
RISK OF INJURY AND APPLIANCE DAMAGE!
•
Always carry out transport with a second person.
•
Do not cut packaging material with a sharp object, e.g. carpet knife.
Removing transport protection
The appliance and some of the interior parts are secured for transport.
✓ Remove all adhesive strips on the right and left sides of the appliance door and
the polystyrene parts from the condenser
on the model).
✓ Remove all adhesive tapes and packaging parts from the interior of the appliance.
✓ Remove residues of adhesive with alkaline water.
✓ There may be stickers with warnings on the appliance. These must be observed
and not removed from the appliance.
10.1 Changing the door hinge
The door hinge of the appliance can be shifted from left to right or vice versa.
APPLIANCE DAMAGE!
Do not tilt the appliance more than 45° when mounting the door in order not to damage
the refrigerating system.
1
condenser = liquefier
Setting up and connecting
1
on the rear of the appliance (depending
Page | 29
Publicidad
