Publicidad
Idiomas disponibles
Idiomas disponibles
Start-up and use
GB
! The first time you use your appliance, heat the empty oven with its door closed
at its maximum temperature for at least half an hour. Make sure that the room
is well ventilated before switching the oven off and opening the oven door. The
appliance may emit a slightly unpleasant odour caused by protective substances
used during the manufacturing process burning away.
! To make the setting process easier, keep the knob in position: this will
increase the scrolling speed of the numbers on the display.
! Each setting will automatically be stored in the appliance memory after 10
seconds.
! The touch controls cannot be activated if the user is wearing gloves.
Some models are equipped with a system of hinges which allows the door to
close slowly, without the user having to follow the movement through with his/
her hand. To use the system correctly, before closing the door:
• Open the door fully.
• Do not force the closing movement manually.
! In order to optimise the cooking performance, when starting the selected
function, product settings will be applied that could cause a delayed start of
the fan and heating elements.
Control panel lock
! The control panel can be locked while the oven is off, once cooking has
started or finished and during programming.
To lock the door and the oven controls, press and hold the
at least 2 seconds. A buzzer sounds and the display shows the key symbol
"n—O". The
and
To deactivate the lock, press and hold the
seconds.
! When cleaning the appliance, the door lock may be closed accidentally
(there is an exposed spring). If this happens, reopen it by turning the door
lock upwards (see figure).
KO
Setting the clock
! The clock can only be set when the oven is switched off. If the oven is in
standby mode, pressing the
setting. Press it again to set the time.
26
WARNING! The oven is provided with
a stop system to extract the racks and
prevent them from coming out of the
oven (1).
As shown in the drawing, to extract
them completely, simply lift the racks,
holding them on the front part, and
pull (2).
icons, when lit, indicate lock function activation.
button again for at least 2
OK
button once will display the current time
After connection to the power supply network or after a blackout, the
button and the digits on the display will flash for 10 seconds.
To set the clock:
1. Press button
.
2. Turn the TIMER knob towards " " and " " to adjust the hour value.
3. Once you have reached the correct hour value, press the
4. Repeat the above process to set the minutes.
If a blackout occurs, it will be necessary to reset the clock. If the
flashes on the display, this indicates that the clock has not been set correctly.
Setting the minute minder
! The minute minder may still be set whether the oven is switched on or off.
It does not switch the oven on or off.
When the set time has elapsed, the timer emits a buzzer that will automatically
stop after 30 seconds or when any active button on the control panel is
pressed.
To adjust the timer proceed as follows:
1. Press button
.
2. Adjust the time as desired by turning the TIMER knob towards " " and " ".
3. Once you have reached the desired value, press the
The lit
symbol will remind you that the minute minder is on. The DISPLAY
will show the countdown.
To cancel the minute minder, press the
the time to 00:00. Press button again.
The
icon will switch off to indicate that the minute minder has been
disabled.
Starting the oven
1. Switch the control panel on by pressing the
buzzer sounds three times (ascending) and all buttons light up in sequence.
2. Select the desired cooking mode by turning the SELECTOR knob. The
display shows:
- the temperature associated with the mode, if programming manually;
- "Auto" and the duration alternately, if programming is automatic.
button for
3. Press the
button to begin cooking.
4. The oven will begin its preheating phase, the preheating indicators will light
up as the temperature rises.
5. When the preheating process has finished, a buzzer sounds and all the
preheating indicator lights show that this stage has been completed: the food
can then be placed in the oven.
6. During cooking it is always possible to:
- modify the temperature by turning the THERMOSTAT knob (manual
modes only);
- set the duration of a cooking mode (see Cooking Modes);
- press the
button to stop cooking. In this case the appliance stores the
temperature modified previously in its memory (manual modes only);
- switch off the oven by pressing the
7. If a blackout occurs while the oven is already in operation, an automatic
system within the appliance will reactivate the cooking mode from the point at
which it was interrupted, provided that the temperature has not dropped below
a certain level. Programmed cooking modes which have not yet started will
not be restored and must be reprogrammed (for example: a cooking mode
has been programmed to start at 20:30. At 19:30 a blackout occurs. When the
power supply is restored, the mode will have to be reprogrammed).
button.
icon
button again.
button and use the knob to set
button. The appliance
button for 3 seconds.
Publicidad
