Publicidad
Idiomas disponibles
Idiomas disponibles
1. N
1.1 g
enerAl notes on sAfety
This technical document is applicable for the machine
BRUSHmax 3.0 The machine may only be handled by
personnel who are qualified.
Hold power tools by insulated gripping surfaces when
performing an operation where the cutting tool may con-
tact hidden wiring or its own cord. Contact with a «live»
wire will make exposed metal parts of the tool «live» and
shock the operator.
WARNING Read all safety warnings and all in-
structions. Failure to follow the warnings and in-
structions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future refer-
ence.
1.2 u
se of the mAchine for PurPoses for
which it is intended
The stainless steel cleaning device (pickling device)may
only be used for the electrolytic processing methods de-
scribed in these instruction. Inappropriate uses are not
permitted.
1.3 i
ncorrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 ec
declArAtion of conformity
Translations of the «EG-Koformitätserklärung (Original)».
SUHNER
Schweiz
AG,
5242 Lupfig, hereby declares under sole responsibil-
ity that the product with the serial or batch no. (see
reverse side) complies with the requirements un-
der the Directive 2014/30/EU, 2014/35/EU. Applied
standards:
EN
60974-1:2021,
Document Agent: T. Fischer. CH-Lupfig, 07/2023.
T. Fischer/Managing Division manager
2. C
2.1 s
i
Afety
nsctructions for commissioning
Before using the BRUSHmax 3.0, make
sure the work area is well ventilated and
there are no flammable substances near-
by. Before each start-up, the mains cable, the mains plug,
the electrode cable, the cleaning electrode, the handle,
the ground cable and the workpiece clamp must be che-
20
S
oTES oN
aFETy
Industriestrasse
10,
CH-
EN
60974-10:2020.
ommISSIoNINg
cked for external damage.
Place the device in a dry place or make sure that it cannot
fall down.
Route cables so that people cannot trip over them.
2.2 m
Ains connection
Ensure that the voltage specified on the rating plate is
compatible with the rated voltage of your AC voltage sup-
ply.
2.3 c
onnecting the cABles
Moulded grip cable (1), Moulded grip cable with marking
electrode (2), earth clamp cable(3)
2.4 r
Ating dAtA
Supply voltage
Fuse
Power cable
No-load output voltage
Output current
Output load
Efficiency
No-load power input
Power factor
Housing LxWxH
Weight
Protection class
EMC classe
2.5 o
PerAting conditions
Ambient air temperature range:
•
+5°C to +40°C,
•
during transport and storage -40°C to +80°C
relative humidity:
•
up to 50% at 40°C
•
up to 90% at 20°C
Ambient air must be free from abnormal amounts of dust,
acids, corrosive gases or substances, etc., other than
those generated by welding.
Examples of unusual operating conditions:
•
unusual corrosive smoke,
•
steam,
•
excessive oil haze,
230V/240V
10Amp
3x1.5qmm
5-18V
65A max
900W / 100%
85%
43W
0.75
350x133x213mm
7.5kg
IP23
A
Publicidad
