Publicidad
Idiomas disponibles
Idiomas disponibles
•
unusual vibrations or shocks,
•
excessive dust such as grinding dust, etc.,
•
harsh weather conditions,
•
unusual seacoast or shipboard conditions.
Ensure free supply and exhaust air when setting up the
device.
The device has been tested according to protection class
IP23, which means:
•
Protection against ingress of solid foreign bodies Ø>
12mm,
•
Protection against spray water up to an angle of 60°
from the vertical.
3.
haNDLINg
3.1 s
Afety instructions for oPerAtion
Never place the cleaning brush or the
handle on the workpiece or work surface
in such a way that the electrode or the car-
bon fiber cleaning brush can come into contact with the
metal surface. Otherwise current will continue to flow,
which can lead to damage or even danger.
Always switch off the device before changing the carbon
brushes.
Over extended treatment periods, the tempera-
ture of the carbon brush can reach as high as
200°C (400°F).
stant gloves, apron, respirator mask and goggles).
Warning corrosive substances: If the electrolyte
comes into contact with your skin or face, you
should rinse the affected areas of skin with plenty
of water immediatley. If you continue to experience any
discomfort, visit a doctor: do not forget to take the label
with you.
Do not eat or drink at the workplace. After working with
electrolytes, always wash your hands thoroughly with
soap and plenty of water.
Excessive smoke is an indication that the power
setting is too high. The result is a high brush and
electrolyte consumption!
3.2 P
ower regulAtor
With the power regulator, the desired cleaning intensity
can be infinitely adjusted to the weld seam to be encoun-
tered. The required cleaning power depends on the wel-
ding process, the material thickness and the weld seam
quality.
/ o
PERaTIoN
You must wear suitable
protective clothing when
using the device (acid-resi-
3.2.1 c
leAning
Only use the brush tip to clean.
The container must be close to the workplace, as the
brush must be regularly dipped in the liquid.
1.
The brush and the surface to be cleaned must be
kept moist with the „SE-70 cleaning and polishing
electrolyte" during the cleaning process.
2.
At the end spray with the„SN-10" neutralizer.
3.
Rinse well with clear water to remove all the electro-
lyte.
4.
Clean thoroughly after use (see chapter 4. Service /
Maintenance).
3.2.2 P
olishing
Only use the brush tip to clean.
The container must be close to the workplace, as the
brush must be regularly dipped in the liquid.
1.
The brush and the surface to be cleaned must be
kept moist with the „SE-70 cleaning and polishing
electrolyte" during the polishing process.
2.
Am Ende mit dem „SN-10" Neutralisierer einsprühen.
3.
Rinse well with clear water to remove all the electro-
lyte.
4.
Clean thoroughly after use (see chapter 4. Service /
Maintenance).
21
Publicidad
