Descargar Imprimir esta página

SUHNER ABRASIVE BRUSHmax 3.0 Documentación Técnica página 23

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 28
If hard deposits pads form on or in the threads of the
brush, wand or handle, clean them with a mini wire brush.
The threads could otherwise seize and the cleaning per-
formance could be reduced or completely lost.
4.2 c
Are of the eArth clAmP
Dirt, corrosion or deposits on the earth clamp can af-
fect the electrical continuity, which reduces the clea-
ning performance!
1.
Turn off the device.
2.
Disconnect the earth clamp from the BRUSHmax 3.0
3.
Lock the clamp in a vice with soft jaws.
4.
Clean the clamp and especially the prongs with a fine
wire brush.
The earth clamp now has the full electrical continuity
again.
4.3 t
rouBleshooting
m
alfUnction
The device is
switched on, but
Check the connection cable to the
there is no light
plug.
on
The output current is too high: Make
sure that the brush has been moiste-
The device shuts
ned with the cleaning solution.
down and the red
LED lights up
Switch-on duration exceeded: Allow
the device to cool down.
Poor electrical contact:
CAUTION hot surfaces: a loose con-
nection can be extremely hot!
Make sure that none of the cables
The device is
is damaged and that they are all
switched on,
properly connected. To ensure good
but its cleaning
contact, you may have to carefully
performance is
adjust the earth clamp.
poor
Dirt on the earth clamp can affect
contact quality, so make sure that the
earth clamp is clean.
Ensure that the brush is tightly
screwed in the wand.
If you encounter any problems not mentioned here,
please contact SUHNER.
4.4 r
ePAir
If despite strict observance of the manufacturing and test-
ing method the machine should happen to fail, it must be
repaired by an authorized SUHNER agency.
4.5 d
/ e
isPosAl
nVironmentAl comPAtiBility
This machine consists of materials which can be dis-
posed of in a recycling process.
Before disposal, render the machine unusable.
Do not throw the machine into the garbage collec-
tion.
According to national regulations this machine
must be recycled in an environmentally-friendly manner.
m
easUre
23

Publicidad

loading