Publicidad
Idiomas disponibles
Idiomas disponibles
Only use suitable Metabo chucks (order no.
3.01.00.301.0) when using the machine.
Hold tool by insulated gripping surfaces
when performing an operation where the
cutting tool may contact hidden wiring.
Contact with a "live" wire will make exposed
metal parts of the tool "live" and shock the
operator.
SYMBOLS ON THE TOOL
V
volts
direct current
n
no load speed
0
../min
revolutions per minute
4 Functional Description
See page 3 (please unfold).
1
Rapid-action keyless chuck
2
Selector barrel (torque, drilling)
3
Slide-switch (1st/2nd gear)
4
Battery-pack release button
5
Battery pack
6
Depot for screwdriver bits
7
Trigger switch
8
Changeover switch (direction of rotation
setting, transporting safety device)
5 Assembly, Operation
Charge the battery pack before use.
Only once it has been charged and discharged
five times (charging cycles) does the battery
pack reach its full charging capacity.
The temperature range for charging is 0 - 50°C.
The number of possible charging cycles varies
depending on the particular charger in use.
• ACS 15, ACS 15 Plus: max. 1500
• AC 30, AC 30 Plus, C 45 Car: max. 1000
However, the specified number of charge
cycles is only reached if an exhaustive
discharge of the battery pack is avoided. If
performance diminishes, recharge the battery
pack.
Store charged NiMH battery packs and
recharge them after an interval of no more than
six months.
5.1
Removing and replacing the battery-
pack
Removing
Press in the release button (4) and remove the
battery pack (5).
Replacing
Push the battery pack (5) fully into its housing
until it locks into position.
5.2
Setting the direction of rotation,
engaging the transporting safety
device (switch-on lock)
Only activate the changeover switch
(8) when the motor is at a standstill!
Activate the changeover switch (direction of
rotation setting, transporting safety device) (8).
See page 3 (please unfold):
R = right-hand rotation selected
L = left-hand (reverse) rotation selected
0 = central setting: transporting position
(switch-on lock engaged)
5.3
Selecting gear
Do not operate the slide-switch (3)
unless the motor is at a standstill.
Position the slide-switch (3) as required:
= 1st gear (low speed, exceptionally high
torque)
= 2nd gear (high speed)
5.4
Setting torque control,
drilling
Turn selector barrel (torque, drilling) (2).
1...20 = Torque setting
(with torque control)
= Drill setting
(max. torque)
5.5
Switching the power tool on and off,
setting speed
Position the trigger-switch (7) as required.
The speed can be set to any value within its
range.
Note:The noise that the machine makes when
it is switched off is due to the model (quick
stop) and has no influence on the function or
the service life of the machine.
ENGLISH
ENG
7
Publicidad
